Time servers (rack and din-rail) are delivered as two main components:
- independent ntpserver case
- external IP65 GPS receiver
GPS Single receiver
- Waterproof IP 65 external receiver with built in GPS active antenna.
- Powered from Time Server.
- 9..12V DC / 300 mA
- Wall mounting
- Connection to server with twisted pair TP cable
- 1 pair for DATA
- 1 pair for PPS signal
- + 2wire DC power
- max cable length: 200m
GPS Dual receiver
- Waterproof IP 65 external receiver with built in GPS active antenna.
- Powered from Time Server.
- 9..12V DC / 300 mA
- Wall mounting
- Connection to server with twisted pair TP cable
- 1 pair for DATA
- 1 pair for PPS signal
- + 2wire DC power
- max cable length: 200m
Cable schematics
- It is strongly recommended to use standard TP cable for ethernet networks. It is low cost and good solution.
- Low impedance chip drivers are used on gps receiver board
- Time server is mounted with 100 Ohm resistors on both lines: DATA, PPS, to minimize glitches and noise.
- GPS DATA baudrate: 9600b/sec
- Protocol: ZODIAC connexant
